
C A R E A N D M A I N T E N A N C E
The porcelain may pop off the edge of the grates
to rapid temperature change when the burners
turned on, Do not be concerned as this does not
the deterioration of the grates. The cast iron
to blend with the porcelain enamel. Be careful when wiping
an area where the porcelain has
For proper lighting and performance keep the
burners clean. It is necessary to clean the burners
if they do not light even through the igniter clicks, if
there has been a severe boil over, or when the flame
Always clean all the burners ports by inserting a thin wire
Before attempting to clean the burners
have been designed for ease in cleaning. When
grates and burners are cool, remove the grate
Wash these parts in hot soapy water, rinse
The Burner Caps are porcelain
enameled, follow the directions on the previous page
given for the burner grates.
to clean burners and top grates if ports remain
clogged use thin wire to clean each port.
After cleaning, it is important to make sure the
Locating Notch at the bottom of the Burner Base
properly aligned with the Burner Cap.
produce a potentially dangerous flame
and poor burner performance.
not to damage the igniter
LOW BACK, OR HIGH SHELF (IF INSTALLED)
Depending on the model, these are constructed of
or a combination of stainless
steel and aluminized steel
hot soapy water, rinse and dry
remaining, try a general kitchen
such as Fantastik®, Simple Green®, or
For hard to clean soil use a stainless
Keepers Friend. Apply cleaner with a damp
direction of the grain. Do not use a stee
it will scratch the surface. To touch up noticeable
scratches in the stainless steel, sand very lightly with
dry100 grit emery paper, rubbing in the direction
the grain. After cleaning use a stainless steel
polish, such as Stainless Steel Magic®
01 23K Btu Burner Head 3 Rows
The burner grates are matte porcelain ename
the dishwasher, or wipe while on the rangetop
using hot soapy water, then rinsed and wiped dry
not rust as they are matte
on both sides for durability
The occasional use of mild abrasive cleaners such
Ami®, Soft Scrub®. Abrasive cleansers,
usedvigorously or too often, can eventually harm
the enamel. Apply with a damp sponge, rinse
When lifting the grates, be careful as they are heavy
Place them on a protected surface, so they won't
scratch the surface they are laid on
the burners and allow the grates to coo
before starring to clean the rangetop. If you wipe
off any part of the rangetop while it is hot do so
carefully as using a wet sponge or cloth can result
, such as soft Scrub®, cameo of Bar
owing package directions. Rinse and dry.
eaners, such as Easy Off®
the racks. However, some commercial oven c
If the top burner are used extensively on high it is possible
for the vertical stainless steel panel to discolor
burner heat. This discoloration can be
usingRevereWareStainlessSteelCleaner.
ight the open top burners, turn the contro
lighted match to the port
Adjust the flame to the desired height
ight each burner individua
than one burner at a time.
Kommentare zu diesen Handbüchern